December/2019 New Braindump2go 300-370 Dumps with PDF and VCE Free Updated Today! Following are some new 300-370 Exam Questions!
New Question
You recently deployed an 802.11ac wireless network that contains Cisco Unified Wireless IP Phones 7925G. Users report that the phones intermittently lose connectivity.
Which troubleshooting step is the first you must take if you are using the bottom-up troubleshooting methodology?
A. Review the Cisco WLC log files for authentication failures.
B. Use a packet sniffer to capture 802.22 frames.
C. Perform an RF site survey.
D. Compare the Cisco IOS version of the controller and the phones.
Answer: C
New Question
You are troubleshooting an AP that fails to join a WLC. Which step of the DTLS handshake is first when establishing a secure CAPWAP connection?
A. ServerHello
B. HelloVerifyRequest
C. Server-ChangeCipherSpec
D. ClientHello
Answer: D
New Question
Which three options can be configured as roaming triggers on a WGB? (Choose three.)
A. SNR
B. co-channel interference
C. RSSI
D. packet fragmentation
E. packet retries
F. minimum data rate
Answer: CEF
New Question
All corporate-issued devices in your network have been configured with EAP-TLS authentication. They authenticate via wireless to an instance of Cisco ISE and AD authorization for the user profiles is un-configured. Which impact occurs to the authentication when a user’s Active Directory username and password expires?
A. The ISE prompts the user for the new password.
B. The user must change the password manually on their WLAN profile.
C. The WLAN profile must be forgotten and reconfigured.
D. WLAN connectivity is not impacted because EAP-TLS uses certificates.
Answer: D
New Question
Clients are maintaining association to access points that they were previously connected to rather than roaming to adjacent access points with higher received signal strength. Which two actions can be taken to fix this issue? (Choose two.)
A. Set DCA channel sensitivity to low.
B. Utilize Rx-SOP.
C. Increase access point power.
D. Enable optimized roaming.
E. Add access points to the areA.
Answer: AD
New Question
Refer to the exhibit. An engineer has determined that during a recent controller failure, some access points did not fail over to their secondary controller, which has sufficient licenses for all APs. The controllers are not in a mobility group, but have A records for their hostnames in DNS. Using these high availability settings, which option is the most likely cause of this issue?
A. The AP failover priority was not set high enough.
B. The controllers must be in the same mobility.
C. DNS hostnames are required to be FQDN.
D. The secondary controller IP address is incorrect.
Answer: A
New Question
Which three components are needed to identify the zone of impact for non-802.11 sources of 2.4 GHz and 5.0 GHz interference? (Choose three.)
A. WLC
B. MSE
C. RF site survey tool
D. Wi-Fi analyzer
E. CleanAir AP
F. spectrum analyzer
Answer: CEF
New Question
You detect a coverage hole in some part of the network. After troubleshooting, you find out that the Cisco 3702i AP is not using all of its transmission power, and hence is not using the 4×4 spatial stream.
Which cause of the problem is true?
A. The upstream switch is not PoE-capable.
B. The AP antennas have been damaged.
C. The AP is not 4×4-capable.
D. The PoE source is not injecting the adequate quantity of power.
Answer: D
New Question
Refer to the exhibit. Why did Client 00:25:84:61:92:7d not get a response from the RADIUS server?
A. The RADIUS server rejected the username that was provided by the client.
B. The shared-secret keys on the controller and on the RADIUS server do not match.
C. The wireless controller does not have IP connectivity to the RADIUS server.
D. The client and the RADIUS server did not agree on the EAP type so the RADIUS server dropped the packet.
Answer: B
New Question
Clients are maintaining association to access points that they were previously connected to rather than roaming to adjacent access points with higher received signal strength. Which two actions can be taken to fix this issue? (Choose two.)
A. Set DCA channel sensitivity to low.
B. Utilize Rx-SOP.
C. Increase access point power.
D. Enable optimized roaming.
E. Add access points to the areA.
Answer: AD
New Question
Refer to the exhibit. An engineer has determined that during a recent controller failure, some access points did not fail over to their secondary controller, which has sufficient licenses for all APs. The controllers are not in a mobility group, but have A records for their hostnames in DNS. Using these high availability settings, which option is the most likely cause of this issue?
A. The AP failover priority was not set high enough.
B. The controllers must be in the same mobility.
C. DNS hostnames are required to be FQDN.
D. The secondary controller IP address is incorrect.
Answer: A
New Question
Which three components are needed to identify the zone of impact for non-802.11 sources of 2.4 GHz and 5.0 GHz interference? (Choose three.)
A. WLC
B. MSE
C. RF site survey tool
D. Wi-Fi analyzer
E. CleanAir AP
F. spectrum analyzer
Answer: CEF
New Question
You detect a coverage hole in some part of the network. After troubleshooting, you find out that the Cisco 3702i AP is not using all of its transmission power, and hence is not using the 4×4 spatial stream.
Which cause of the problem is true?
A. The upstream switch is not PoE-capable.
B. The AP antennas have been damaged.
C. The AP is not 4×4-capable.
D. The PoE source is not injecting the adequate quantity of power.
Answer: D
New Question
Refer to the exhibit. Why did Client 00:25:84:61:92:7d not get a response from the RADIUS server?
A. The RADIUS server rejected the username that was provided by the client.
B. The shared-secret keys on the controller and on the RADIUS server do not match.
C. The wireless controller does not have IP connectivity to the RADIUS server.
D. The client and the RADIUS server did not agree on the EAP type so the RADIUS server dropped the packet.
Answer: B
1.|2019 Latest Braindump2go 300-370 Exam Dumps (VCE & PDF) Instant Download:
https://www.braindump2go.com/300-370.html
2.|2019 Latest Braindump2go 300-370 Exam Questions & Answers Instant Download:
https://drive.google.com/drive/folders/0B75b5xYLjSSNdGVBOXFERG9OSFU?usp=sharing